Grain Saver

10" Double Hopper Unload Tube

10" double hopper bin unload tubes ship fully assembled and ready to install in a poured concrete foundation or under a drying/aeration floor. Roller slide gates, sweep pivot pin, control rods, a...

10" Grain Saver U-Trough (Power Sweep Unload Systems)

10" Grain Save U-trough, fitted for larger 10" powersweep unload systems. It carries grain from the sweep to the powerhead with more capacity for bigger bins and faster unloads.

10" Unload Screw

10" unload screws are right-hand, full pitch, and welded to the screw shaft every 1.5 pitches for durability. Drilled to fit most powerhead output shafts.Important: never start or stop the auger...

5" Bin Sweep (for 6" or 8" Tubes)

5" bin sweep for 6" or 8" tubes, including the formed steel backboard, drive wheel, easy-off motor mount, driven sheaves, belts and belt guards. Tip: use the smallest motor sheave that fits the drive...

7" Bin Sweep (for 10" Tubes)

7" bin sweep for 10" tubes, complete with the formed steel backboard, drive wheel, easy-off motor mount, driven sheaves, belts and belt guard. Use the smallest motor sheave that fits the drive motor...

8" Double Hopper Unload Tube

8" double hopper bin unload tubes arrive completely assembled and ready to drop into a poured concrete foundation or under a drying/aeration floor. Roller slide gates, sweep pivot pin, control rods,...

8" Grain Saver U-Trough (Power Sweep Unload Systems)

8" Grain Save U-trough for powersweep unload systems. The U-trough channels grain from the sweep to the powerhead, keeping your unload clean and contained right to the outlet.

8" Unload Screw

8" unload screws are right-hand, full pitch, and welded to the screw shaft every 1.5 pitches for strength. Drilled to fit most powerhead output shafts.Important: never start or stop the auger under...

Center Sump Clump Buster

The center sump clump buster fits over most center sumps for grain bin unload tubes and powersweeps, breaking up clumps so grain keeps flowing instead of bridging up and stalling your unload.

Horizontal Powerhead

The horizontal powerhead drives your bin unload system, and the innovative easy-off motor mount makes service quick — with an over-center belt tightener as standard. The two-belt cast aluminum...

Horizontal Powerhead - U-Trough

Horizontal powerhead built for a U-trough unload setup — just choose 8" or 10" trough to match your system. It drives the U-trough sweep and keeps grain moving smoothly to the outlet.

Inclined Powerhead - 25 degree

25-degree inclined powerhead for bin unload systems, supplied complete with electric motor mount, driven pulley, drive belts and drive shields. Support stands are available at extra cost.