Shop All

7" Bin Sweep (for 10" Tubes)

7" bin sweep for 10" tubes, complete with the formed steel backboard, drive wheel, easy-off motor mount, driven sheaves, belts and belt guard. Use the smallest motor sheave that fits the drive motor for slower, gentler sweep auger rotation.

Low Speed Centrifugal Fan - 1750 RPM

Low-speed centrifugal fans from Caldwell and AGI, turning at 1750 RPM for quieter, efficient airflow at higher static pressures — ideal for larger bins and deep grain.Choose from 5 HP all the way up to 25 HP, in single- and three-phase, with...

Inclined Powerhead for U-Trough - 22 degree

22-degree inclined powerhead fitted for the U-trough system, giving you the lift you need to move grain up and out. A clean match for U-trough powersweep unload setups.

Horizontal Powerhead - U-Trough

Horizontal powerhead built for a U-trough unload setup — just choose 8" or 10" trough to match your system. It drives the U-trough sweep and keeps grain moving smoothly to the outlet.

10" Grain Saver U-Trough (Power Sweep Unload Systems)

10" Grain Save U-trough, fitted for larger 10" powersweep unload systems. It carries grain from the sweep to the powerhead with more capacity for bigger bins and faster unloads.

8" Grain Saver U-Trough (Power Sweep Unload Systems)

8" Grain Save U-trough for powersweep unload systems. The U-trough channels grain from the sweep to the powerhead, keeping your unload clean and contained right to the outlet.

Reduction Wheel End Drive Kit

Reduction wheel end drive kits in 5:1 and 10:1 ratios, fitted for both 8" and 10" powersweeps. The 5:1 ratio suits bins 36' and smaller; the 10:1 ratio is best for bins 42' and larger. Pick the ratio that matches your bin and you're set.

Replacement Wheels (carry-in or Powersweeps)

Replacement wheels and replacement reduction wheels for your carry-in sweeps and powersweeps. Worn wheels rob you of traction and drive — swap them out and keep the sweep moving.

5" Bin Sweep (for 6" or 8" Tubes)

5" bin sweep for 6" or 8" tubes, including the formed steel backboard, drive wheel, easy-off motor mount, driven sheaves, belts and belt guards. Tip: use the smallest motor sheave that fits the drive motor — it gives you slower sweep auger...

Unload Tube Plates/Flanges

Bin wall plates flash the opening cut in the bin wall for an unload tube, and hopper flanges flash the area in the drying or aeration floor. Together they give your unload tube a clean, sealed, finished install.

Powersweep Gearbox (upper or lower)

Replacement gearbox for the upper or lower section of your powersweep. Keep your sweep turning and your bin unloading without hunting around for the right part — just pick upper or lower.

Center Sump Clump Buster

The center sump clump buster fits over most center sumps for grain bin unload tubes and powersweeps, breaking up clumps so grain keeps flowing instead of bridging up and stalling your unload.